product-h.gif (4742 個位元組)

025.gif (410 bytes)Production Procedures

025.gif (410 bytes)Quality of Strategy

025.gif (410 bytes)Material Introduction

025.gif (410 bytes)Special Property

025.gif (410 bytes)Purpose

025.gif (410 bytes)Comparatively

025.gif (410 bytes)To Choose Insoles

025.gif (410 bytes)About Foul Smell

025.gif (410 bytes)How to Use Insoles

025.gif (410 bytes)Product Information

025.gif (410 bytes)Jumpec New Materials

025.gif (410 bytes)Fabric Information

025.gif (410 bytes)Sporting Supporters

025.gif (410 bytes)How to Place Oder

　


Comparatively
s-006.jpg (4993 個位元組)

Open-Cell Structure:
No matter it is viewed form top or side, many pores are observed which contribute to good ventilation and moist absorption ability. POLIYOU stands out for this structure.
s-007.jpg (6823 個位元組)

Half-Open-Cell structure:

In this structure, about 20% to 40% of surface are covered by thin membrane. It is easier to see from escaping. As a consequence, moisture captured at the membrane becomes solidified and are forced to return to surface due to external pressure, causing adverse effect. PU sponge Latex Foam belongs to his Categopry.
s-008.jpg (5748 個位元組)

Close-Cell Structure:

Both top and side views exhibit concaves like that of surface of the moon. The rest area is tight neither moisture nor air may travel through. The surface of this type of material will hence detain water, resulting uncomfortable of wearing. EVA, PU liq casting products and PE are this type.
 Comparative Statement Between POLIYOU®

　

Copyright© 2000 KUN HUANG Enterprise Corporation. All rights reserved
Service Tel:886-37-983505             Service Mail: Vincent Huang